Adjusting The Saw Prior To Use - Hitachi Koki C 7BMR Mode D'emploi

ADJUSTSING THE SAW PRIOR TO USE
WARNING:
To avoid serious accidents, ensure the switch is
in OFF position, and disconnect the plug from the
receptacle.
1. Adjusting the cutting depth (Fig. 3)
WARNING:
If the lever (A) is loose, injury can result. Tighten
it securely after adjustment.
To adjust cutting depth, loosen the lever (A) and,
while holding the base with one hand, move the
main body up and down to obtain the prescribed
cutting depth. After adjusting to the prescribed
cutting depth, tighten the lever (A) securely.
Loosen
Tighten
2. Adjusting the angle of inclination
WARNING:
If the lever (A) is loose, injury can result. Tighten
it securely after adjustment.
You can incline saw blade from 0˚ to a maximun
angle of 55˚ in relation to the base.
As shown in Fig. 4 by loosing the lever (A) on the
bevel scale, the saw blade may be inclined to an
angle of 45˚ in relation to the base.
Lever (A)
Base
Fig. 3
Lever (A)
If you use inclination angle of over 45˚, as shown
in Fig. 5 move the lever (A) to inside, the saw blade
may be inclined to a maximum angle of 55˚ in
relation to the base.
Always ensure that the lever (A) is thoroughly
tightened after making the desired adjustment.
45˚ – 55˚
3. Regulating the guide (Rip fence) (Fig. 6, 7)
................................................ Optional Accessory
Install the wing bolt (B) and lock spring on the base.
Insert the guide into the base, move it left and right
and adjust the cutting position. Tighten the wing
bolt (B) and fix the guide. The guide can be
installed either from the left or the right side of the
main body.
Wing
bolt (B)
Lock
spring
Base
English
0˚ – 45˚
Fig. 4
Fig. 5
Fig. 6
9