Packaging - WIKA E-10 Mode D'emploi

5. For your safety / 6. Packaging
WARNING!
Consider the respective country specific regulations for installation and operation in
hazardous areas (e.g.: NEC, CEC). If you do not observe these stipulations, serious
injuries and/or damage can occur.

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure transmitters; with flush version E-11 including pre-assem-
■
bled sealings and protection cap.
Inspect the pressure transmitter for possible damage during transportation. Should there be
■
any obvious damage, inform the transport company and WIKA without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing instal-
■
lation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be damaged.
■
In order to protect the diaphragm, the pressure connection of the instrument E-11 is provided
with a special protection cap.
Remove this protection cap only just before installing the pressure transmitter in order to
■
prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for later
■
storage or transport.
Mount the protection cap when removing and transporting the instrument.
■
WIKA operating instructions, models E-10, E-11
US
7