Design And Function; Transport, Packaging And Storage - WIKA S-11 Mode D'emploi

3. Specifications / 4. ... / 5. Transport, packaging and storage
CE conformity
EMC directive 2004/108/EC, EN 61326 emission (group 1, class B) and immunity (industrial
■
application)
Pressure equipment directive 97/23/EC
■
For special model numbers, e.g. S-11000, please note the specifications stated on the delivery note.
For further specifications see WIKA data sheet PE 81.02 and the order documentation.

4. Design and function

4.1 Description
The prevailing pressure is measured at the sensor element through the deformation of a diaphragm.
By supplying power, this deformation of the diaphragm is converted into an electrical signal. The output
signal from the pressure transmitter is amplified and standardised. The output signal is proportional to
the measured pressure.
4.2 Scope of delivery
Cross-check the scope of delivery with the delivery note.

5. Transport, packaging and storage

5.1 Transport
Check the pressure transmitter for any damage that may have been caused during transportation.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site,
sending for repair).
WIKA operating instructions pressure transmitter, model S-11
GB
15