Design And Function; Scope Of Delivery - WIKA MG-1 Mode D'emploi

Masquer les pouces Voir aussi pour MG-1:

Table des Matières

Les langues disponibles

3. Specifications / 4. Design and function

Specifications

Shock resistance

Vibration resistance

Reverse polarity protection

Short-circuit resistance

Weight

1) Including non-linearity, hysteresis, zero-point and full scale value deviations (corresponds to measuring error per IEC 61298-2).

Calibrated in vertical mounting position with process connection facing downwards.

For special model numbers, e. g. MG-10000, please note the specifications stated on the

delivery note.

For further specifications, see WIKA data sheet PE 81.44 and the order documentation.

When designing the system, please note that the values given (e.g. burst pressure,

overpressure safety) are dependent upon the material, thread and gasket used.

4. Design and function

4.1 Description

By means of a sensor element and by applying power, the prevailing pressure is converted into an

amplified standardised electrical signal via the deformation of a membrane. This electrical signal

varies in proportion to the pressure and can be evaluated accordingly.

Cross-check scope of delivery with delivery note.

WIKA operating instructions pressure transmitter model MG-1

Model MG-1

40 (6 ms) per IEC 60068-2-27 (mechanical shock)

20 (20 ... 2000 Hz, 120 min.) per IEC 60068-2-6

(Vibration under resonance)

vs. 0V

approx. 0.08

Table des Matières

Table des Matières