Safety; Intended Use - WIKA MG-1 Mode D'emploi

2. Safety

2. Safety
GB

2.1 Intended use

The pressure transmitter is used to convert pressure into an electrical signal.
The pressure transmitter has been designed and built solely for the intended use described here
and may only be used accordingly.
The technical specifications contained in these operating instructions must be observed. Improper
handling or operation of the pressure transmitter outside of its technical specifications requires
the instrument to be taken out of service immediately and inspected by an authorised WIKA
service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the
intended use.
6
WARNING!
Before installation, commissioning and operation, ensure that the appropriate
pressure transmitter has been selected in terms of measuring range, design and
specific measuring conditions.
Non-observance can result in serious injury and/or damage to the equipment.
Further important safety instructions can be found in the individual chapters of
these operating instructions.
WIKA operating instructions pressure transmitter model MG-1