Ryobi LCD1402 Manuel D'utilisation page 6

GB
FR DE ES
SPECIFICATIONS
MODEL BATTERY PACK
(not included)
BPP-1413
BPP-1415
BPP-1417
LCD1402 BPL1414
BPP-1413
BPP-1415
BPP-1417
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Drilling in all types of wood products (lumber, plywood,
Q
paneling, composition board, and hard board)
Drilling in ceramics, plastics, fiberglass, and laminates
Q
Drilling in metals
Q
Mixing paint
Q
This product will accept Ryobi 14.4 V lithium-ion battery
packs and Ryobi 14.4 V nickel-cadmium battery packs.
WARNING
Always remove battery pack from your drill when
you are assembling parts, making adjustments,
assembling or removing bits, cleaning,
or when not in use. Removing battery pack will
prevent accidental starting that could cause serious
personal injury.
IT NL PT DK SE
CHARGER
(not included)
BCL1418
BC-1440
BC-1415-S
BCA-144
FI NO RU PL CZ
English
BATTERY PROTECTION FEATURES
Ryobi 14.4 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
TO INSTALL BATTERY PACK
See Figure 2.
Place the rotation selector in the center position.
Q
Insert the battery pack into the product as shown.
Q
Make sure the latches on each side of the battery
Q
pack snap in place and that battery pack is secured in
the product before beginning operation.
TO REMOVE BATTERY PACK
Depress the latches on each side of the battery pack.
Q
Remove the battery pack from the drill.
Q
WARNING
Battery products are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
SWITCH TRIGGER
See Figure 3.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed
with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
2
HU RO LV LT EE HR SI SK GR TR