Milwaukee 6088-30 Manuel De L'utilisateur page 6

To reduce the risk of injury, wear safety goggles or glasses with
side shields.
Starting and Stopping the Motor
1. To start the tool, pull the trigger.
2. To stop the tool, release the trigger.
To reduce the risk of injury or damage to the tool, do not use the
spindle lock button to stop the spindle while the tool is in use or
is coasting after shut-off.
Locking the Trigger
Select Models
The lock button holds the trigger in the ON position for continuous use.
Fig. 4
1. To lock the trigger on, hold the lock-on button in while pulling the trigger.
Release the trigger.
2. To unlock the trigger, pull the trigger and release. The lock-on button
will pop out.
page 6
WARNING
WARNING
Lock-on button
OPERATION
To reduce the risk of injury, do not operate tool with handle re-
lease button pressed in or with handle not locked into position.
If the handle does not lock securely into position, do not operate
tool. Return the tool to a MILWAUKEE service facility for repair
immediately.
Adjusting the Rear Handle Position
Select Models
This tool is equipped with an adjustable rear handle. This feature
allows the user to adjust the angle of the handle to nine positions for op-
timum operating positions.
Fig. 5
1. Unplug tool.
2. Press and hold the handle release button in and rotate the rear handle
to one of the nine handle positions. The adjustable handle feature has
detents which allow the handle to snap into position. Make sure the
handle snaps fi rmly into position and does not rotate.
Position the guard in the location which offers best control and guard
protection. For operating zones that provide maximum protection for
the operator, see Fig. 9.
To reduce the risk of personal injury and damage to the tool,
use ONLY accessories rated at or above the RPM listed on the
"WARNING" section of the tool's nameplate.
Sanding Disc and Grinding Wheel Selection
Use sanding discs and grinding wheels that are:
• correct size as written on tool's nameplate
• correct wheel type and grit for the job
• rated at or above the RPM listed in the "WARNING" section on
the tool's nameplate
Use backing pads, adapters, and other accessories that are:
• correct size for tool and for sanding disc or grinding wheel
• rated at or above the RPM listed in the "WARNING" section on
the tool's nameplate
• the proper accessory for the job
Sanding Disc and Grinding Wheel Material
Sanding discs and grinding wheels are made of various materials and are
designed for different jobs. Be sure that you choose the proper sanding disc
or grinding wheel for the job you plan to do.
To reduce the risk of injury, always unplug tool before attaching
or removing accessories or making adjustments. Use only specifi -
cally recommended accessories. Others may be hazardous.
WARNING
Handle
release button
(on bottom)
WARNING
WARNING