Software Installation - INFOSEC UPS SYSTEM E4 Value+ Manuel Utilisateur

Output Line
Output Neutral
NOTE 1: Make sure that the wires are firmly connected to the terminals.
NOTE 2: Please install the output breaker between the output terminal and the load, and the circuit breaker
should be qualified with a current leakage protective function if necessary.
6) Put the terminal block cover back on the rear panel of the UPS.
Warning:
● Make sure the UPS is not turned on before installation. The UPS should not be turned on during wiring
connection.

2-4. Software Installation

For optimal computer system protection, install the UPS monitoring software to fully configure UPS
shutdown.
Communication ports:
USB port
To allow for unattended UPS shutdown/start-up and status monitoring, connect one end of the
communication cable to the USB/RS-232 port and the other to the communication port of your PC. With the
monitoring software installed, you can schedule UPS shutdown/start-up and monitor UPS status on your
PC.
The UPS is equipped with an intelligent slot, ideal for either an SNMP or AS400 card. When installing either
an SNMP or AS400 card in the UPS, it will provide advanced communication and monitoring options.
Note: A USB port and RS-232 port cannot work at the same time.
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 10 19 AA 59 204 31
Terminal Block wiring diagram
RS-232 port
Input Neutral
Input Line
Ground
Intelligent slot
34