Fault Code; Warning Indicator; Icon Flashing - INFOSEC UPS SYSTEM E4 Value+ Manuel Utilisateur

LCD display
Description
Battery Test
LCD display
Description
Fault status
LCD display

3-8. Fault Code

Fault
DC Bus start failure
DC Bus over
DC Bus under
DC Bus unbalance
Inverter soft start failure
High Inverter circuit voltage

3-9. Warning Indicator:

Warning
Battery low
Overload
Battery unconnected
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
47
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 10 19 AA 59 204 31
When the UPS is in AC mode or CVCF mode, press the "Test" key for
more than 0.5s. Then the UPS will beep once and start a "Battery Test".
The line between I/P and the inverter icons will flash to remind users.
This operation is used to check the battery status.
When a fault occurs, the UPS will display fault messages on the LCD
panel.
Fault code Icon
01 None Low Inverter circuit voltage
Inverter circuit output short
02 None
03 None Battery SCR short-circuited
04 None
11 None
12 None

icon flashing

Icon (flashing)
Fault
circuited
Over temperature
Overload
Alarm
Beeping every second
Beeping twice every second
Beeping every second
Fault code Icon
13 None
14
21 None
41 None
43