Software Installation; Intelligent Slot - INFOSEC UPS SYSTEM E4 LCD Pro 5000 Manuel Utilisateur

Output Line
Output Neutral
Terminal Block wiring diagram of E4 LCD Pro 5K(S)/6K(S)/8K(S)/10K(S)
NOTE 1: Make sure that the wires are firmly connected to the terminals.
NOTE 2: Please install the output breaker between the output terminal and the load, and the circuit breaker
should be qualified with a current leakage protective function if necessary.
6) Put the terminal block cover back on the rear panel of the UPS.

2-4. Software Installation

For optimal computer system protection, install the UPS monitoring software to fully configure UPS
shutdown.
Communication ports:
USB port
To allow for unattended UPS shutdown/start-up and status monitoring, connect one end of the
communication cable to the USB/RS-232 port and the other to the communication port of your PC. With the
monitoring software installed, you can schedule UPS shutdown/start-up and monitor UPS status on your
PC.
The UPS is equipped with an intelligent slot, ideal for either an SNMP or AS400 card. When installing either
an SNMP or AS400 card in the UPS, it will provide advanced communication and monitoring options.
Note: A USB port and RS-232 port cannot work at the same time.
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
31 Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr –
RS-232 port
03 17 AA 59 204 10
Input Neutral
Input Line
Ground

Intelligent slot