Operating Mode/Status Description - INFOSEC UPS SYSTEM E4 LCD Pro 5000 Manuel Utilisateur

20 Backup time adjustment
*Y (YES) means that this program can be set in this mode.

3-7. Operating Mode/Status Description

Operating mode/status
Description
AC mode
LCD display
Description
CVCF mode
LCD display
Description
Battery mode
LCD display
Description
Bypass mode
LCD display
Battery Test Description
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr –
When the input voltage is within the acceptable range, the UPS will
provide pure and stable AC power to output. The UPS will also charge
the battery in AC mode.
When the input frequency is within 46 to 64Hz, the UPS can be set to a
constant output frequency, 50 Hz or 60 Hz. The UPS will still charge the
battery in this mode.
When the input voltage is beyond the acceptable range or if there is a
power failure, the UPS will back up the power from the battery and the
alarm will beep every 4 seconds.
When the input voltage is within the acceptable range and the bypass is
enabled, turn off the UPS and it will enter in Bypass mode. The alarm
beeps every two minutes.
When the UPS is in AC mode or CVCF mode, press the "Test" key for
more than 0.5s. Then the UPS will beep once and start a "Battery Test".
The line between I/P and the inverter icons will flash to remind users.
03 17 AA 59 204 10
Y Y Y Y Y
38