General Information; Field Of Application Of The Pr2700 - Abus PR2700 Notice De Montage Et D'utilisation

II. General information
The ABUS reinforced door bar provides additional protection against unauthorised break-
ins into rooms. It is suitable for all standard doors made of wood, metal and plastic. Not
all varieties of use for the PR2700 can be adressed with these fitting instructions. Ask a
dealer if necessary.
The optimal protective effect is reached if you proceed according to these fitting and
operating instructions. The mounting screws should be tightened manually with a
suitable tool to avoid overwinding. Prior to fitting, you should ensure that the reinforced
door bar is suitable for the structural circumstances. The manufacturer disclaims all
liability for any injury or damage caused during fitting and/or by improper handling!
We recommend allowing a specially trained specialist installer to execute the fitting.
III. Field of application of the PR2700
The PR2700 is suitable for all hinged and unhinged doors that open inwards and outwards,
DIN right or DIN left (Fig. 2). Doors with panelling and/or border trimmings must be
individually adjusted (use lock underlays if necessary).
The standard design is suitable for doors opening inwards
(door panel width of 735 mm to 1030 mm and door panel thicknesses of 35 to 50 mm).
For doors opening outwards or thick doors, special accessories are available
commercially.
The PR2700 can be fitted with a knob cylinder or a door half-cylinder (without the
possibility of closing from the outside).
The PR2700 can also be equipped with different door cylinders following EN DIN 1303 /
DIN 18252.
We recommend fitting beneath the mounting (Fig. 3).
The fitting of 2 pieces PR2700 is recommended in the event of increased safety require-
ments. One is then fitted above and below the mounting (Fig. 4).
The closing direction can be adjusted according to the door lock.
38