Network Settings; Hdd Management; Setting Up Network Cameras - Abus TVVR45021 Manuel Utilisateur

Network Settings

Note
To check whether DHCP can be selected (or if
you have to set the IP address and other settings
manually), consult your network administrator.
1. DHCP activated: If DHCP is set up in the network
router, then tick the DHCP box. All network settings
are then made automatically.
2. DHCP not activated: Enter the data manually (IPv4
address, IPv4 subnet mask and IPv4default gateway
= IPv4 address of the router). You can also option-
ally enter the address of the DNS server that you
need for sending the E-mail.
A typical address specification is as follows:

IPv4 address:

IPv4 Subnet mask:

IPv4 Default gateway:

Preferred DNS server:
Note
When the device is accessed remotely via the
internet, it should be given a fixed network ad-
dress.
107

HDD Management

1.
2.
3.

Setting up network cameras

192.168.0.50
255.255.255.0
192.168.0.1
192.168.0.1
To set up a new hard disc, activate the "Check box"
with a left click and then click on Init.
Warning
All data on the drive is deleted!
Confirm the prompt by pressing OK. The HDD is
then set up for operation. The progress is displayed
on the status bar.
Exit the setting by pressing Next.
1. To setup network cameras, click on Search.
2. You can find an overview of all the network cam-
eras found below.
3. Activate the "Checkbox" with a left-click to select
the network camera and then click on Add.
4. Click on Next
Setup wizard