Settings In Program Menu - Abus Terxon SX AZ4301 Manuel D'installation

15.3

Settings in program menu

000 Country Settings
Use this setting to configure the burglar alarm centre for
the local country. When you load the country settings, all
user-defined settings are discarded. If you only want to set
the language of the control unit display, use menu item
126 (language).
At the user level, do the following:
1. On the control unit, enter: 0
2. Enter the program code:
The LCD display shows: Progr.Mode
3. On the control unit, enter: 000
4. The LCD display shows: 000:Land=D
5. On the control unit, enter:
6. The LCD display shows: 000:Land=UK
7. On the control unit, enter:
8. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode
You have now made the settings for Germany. Following
this setting, the values mentioned of the program overview
are different from the values set on the burglar alarm
centre.
001 – 008 Zone setting
Under the zone setting menu item, set the zone name and
property.
From the program level, do the following:
1. On the control unit, enter: 001
2. The LCD display shows: 001: ZONE 01
3. The cursor flashes under the first letter.
7890
0
39
4. Enter the zone name (max. 12 characters) via the
keypad.
5. In the following, the zone name "EINGANG" is
entered.
On the control unit, enter:
-
-
-
-
-
-
-
-
-
-
-
-
-
6. If you make a mistake, you can move the cursor
back by pressing the D key
7. You can delete a letter or digit by entering a blank
at the respective position with the 0 key
8. After entering a new zone name, confirm your
input.
On the control unit, enterr:
UK
E
next position ->
I
next position ->
N
next position ->
G
next position ->
A
next position ->
N
next position ->
G
.
.
.