Set The Cutting Height; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks LMF421 Manuel De L'utilisateur

EN
6.7

SET THE CUTTING HEIGHT

The machine can be set to different cutting heights.
1. Pull the height adjustment lever rearward to increase the
cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
6.8

INSTALL THE BATTERY PACK

7
16
15
17
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
The machine has a battery storage compartment that helps
store the battery pack.
1. Open the battery door (7).
2. Align the lift ribs on the battery pack (16) with the
grooves in the battery compartment.
3. Push the battery pack (15) into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
WARNING
NOTE
English
The engine starts only when you put in the safety key (17).
6.9

REMOVE THE BATTERY PACK

1. Open the battery door (7).
2. Remove the safety key (17).
3. Push and hold the battery release button (16).
4. Remove the battery pack (15) from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

1
2
1. Put in the safety key.
2. Push and hold the start button (2).
3. While you hold the start button, pull the bail switch (1) in
the direction of the handle bar.
4. Once the machine has started you can release the start
button.
If the machine does not start, remove the battery pack and
examine the mower deck to make sure that:
• No grass catches on the blade.
• The blade turns freely by hand.
7.2

STOP THE MACHINE

1. Release the bail switch to stop the machine.
10
NOTE
WARNING
NOTE