Set The Blade Height; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks G24LM33 Manuel Opérateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
EN
3.5

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Remove the battery pack and safety key before turning over
the machine to adjust the cutting height.
Figure 6
1. Turn the machine over to access the front and rear cutting
height adjustment.
2. Push the axle forward to unlock the cutting height
adjustment.
3. Move the axle into one of the three positions. Make sure
that the two sides of the axle are in the same height.
4. Make sure that the four wheels are assembled in the same
cutting height and scroll smoothly and unclogged.
3.6

INSTALL THE BATTERY PACK

Figure 7
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The engine starts only when you put in the safety key.
3.7

REMOVE THE BATTERY PACK

Figure 7
1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
WARNING
WARNING
NOTE
WARNING
English
4.1

START THE MACHINE

Figure 8
Install the grass catcher before mowing.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the switch box
handle in the direction of the handle bar.
4. Release the start button to start the machine.
4.2

STOP THE MACHINE

Figure 8
1. Release the switch box handle to stop the machine.
Wait until the blade fully stops before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
4.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
4.4

OPERATE ON SLOPES

Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
Make sure that your footing is stable. If you are out of
balance, release the handle switch immediately.
Do not mow near drop-offs, ditches, or embankments.
6
NOTE
WARNING
WARNING
WARNING

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lmg301

Table des Matières