Laserworld tarm Série Mode D'emploi page 22

Manual: tarm Series
10. Operation Instructions - FB4 Version
The following operation instructions only apply, if the show laser has been purchased
with built-in Pangolin FB4.
With built-in Pangolin FB4 interface, the show laser can be controlled over LAN (network
cable) or ILDA cable. It is possible either to connect a LAN cable directly from the PC
(laptop / tablet) to the laser, or use a network infrastructure (switch, router).
a. Connect the power cable to the device and then to the mains.
b. In order to provide the control signal to the laser device, connect the built-in FB4
interface with the PC or Laptop through network cable (CAT-5 or higher). The
built-in FB4 interface can be controlled directly from a PC (laptop / tablet) over
Pangolin Quick Show or Pangolin Beyond Software.
c. On software startup, the FB4 interface should be automatically detected and it
should show up in the status bar.
d. Connect the interlock adapter to the interlock connector. The show laser doesn't
work if the interlock adapter isn't connected to the device.
In case of problems or for further operation instructions of the Pangolin FB4, please see
the FB4 operation manual. It can be found here:
https://www.laserworld.com/fb4-manual
microSD card
/ up to 64GB
For LAN system connec-
tion to PC with Pangolin
software
The FB4 interface also has a microSD card slot for using playback features. Please see the
FB4 manual for details on how to use this feature.
page 22 / 67
Full-color OLED display
Knob for menu selection: turn
for selection, press for OK