Laserworld tarm Série Mode D'emploi page 14

Manual: tarm Series
To activate ArtNet trigger, open the admin tool and navigate to the tab ‚Settings' . Then
change the ‚Data source for internal DMX effects' to ‚ArtNet input' as seen in the picture
below:
Click on ‚Store Data' to save the changes. Click on ‚OK' twice and wait until another win-
dow opens that asks to restart the ILDA interface. To do so, switch the laser system off
and on again.
See the details on DMX Mode below for more information:
f) DMX Modes
switch 1
Binary DMX 1
channel offset
There are two DMX / ArtNet configuration modes:
(1) DJ Mode & (2) Professional Mode.
The DJ mode is more basic and comes with some pre-configured automations. It is sui-
table for most users.
The Professional mode comes with some advanced features and requires deper know-
ledge of DMX / ArtNet to be handled properly.
DJ mode is the standard option. To use the Professional mode, open the admin tool and
navigate to the tab ‚Settings' .
Change the option.
Click on ‚Store Data' to save your changes. Click on ‚OK' twice and wait until another win-
dow opens that asks to restart the ILDA interface. To do so, switch the laser system off
and on again.
page 14 / 67
2 3 4 5
2 4 8 16
6 7 8 9
32 64 128 256
10
Switch 10 has to be ON (up)
for DMX mode