Laserworld tarm Série Mode D'emploi page 17

Manual: tarm Series
(2) Professional Mode
Channel
1 Intensity
2 Pattern selection
3 Pattern speed
(Framerate)
4 Position X-axis coarse
5 Position X-axis fine
6 Position Y-axis coarse
7 Position Y-axis fine
8 Rotation coarse
9 Rotation fine
10 Size X-axis
11 Size Y-axis
12 Inversion
13 Color Selection
14 Red
15 Green
16 Blue
page 17 / 67
Mode Value
Prof. 0
1 - 255
Prof. 0
1 - 255
Prof. 128
0 - 127
129 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 63
64 - 127
128 - 191
192 - 255
Prof. 0 - 15
16 - 207
208 - 223
224 - 239
240 - 255
Prof. 0 - 255
Prof. 0 - 255
Prof. 0 - 255
Function
Laser off
Increase intensity (full intensity = 255)
Blackout (000.ild must not exist)
Display patterns from SD card:
1 = 001.ild
2 = 002.ild
... and so on
If no pattern is assigned to a number = blackout
Standard speed 50 fps
Increasing speed from 0 fps tp 50 fps
Increasing speed from 50 fps to 100 fps
From left (0) to right (255); center = 128
From bottom (0) to top (255); center = 128
Rotate; 0° = 128
From maximum (0) to minimum (255)
From maximum (0) to minimum (255)
None
Invert X-axis
Invert Y-axis
Invert X + Y-axis
Original pattern colors
Color selection from red (16) through yellow
(48), green (80), cyan (112) and blue (144) up to
purple (176) with color mixtures in between.
White with half intensity for each color channel
White with full intensity for each color channel
Enables channels 14 -16 to select a specific hue
Increase intensity red
Only active if the value of channel 13 is 240 - 255
Increase intensity green
Only active if the value of channel 13 is 240 - 255
Increase intensity blue
Only active if the value of channel 13 is 240 - 255