Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Manual: tarm Series
If DIP switch 4 is activated too, the stand alone mode only plays one specific ILDA file and
just loops this file.
switch
1
On (1) / Off (0)
0
Dip switch 1 can be used to step to the next file (just switch DIP switch 1 to on, then to
off again)
Dip switch 2 can be used to step to the previous file (just switch DIP switch 2 to on, then
to off again)
c)
Demo Mode / Automatic Animation
switch
1
On (1) / Off (0)
0
In demo mode the ILDA files on the integrated SD card are triggered automatically. The
ILDA files are not only played back like in the stand alone mode, but they are also auto-
matically animated by ShowNET's internal intelligence. This creates dynamic animations,
even if only static frames are on the SD card.
This setting is especially suitable for demo purposes.
d)
Master-Slave-Mode: Demo Mode
MASTER Unit:
switch
1
On (1) / Off (0)
0
SLAVE units:
switch
1
On (1) / Off (0)
0
To have the same effects show on all connected units, it is required to have the same
pattern sets on all SD cards inside the units.
e)
ArtNet Operation
IMPORTANT: ArtNet operation requires the show laser system to be connected in a DHCP
environment (router with integrated switch is recommended). The address handling
must be managed through DHCP. For questions on DHCP, please refer to 4.1. DHCP Mode.
Only ShowNET interfaces and the ArtNet controller must be used in the same network.
Avoid using other network devices in the same network.
Use the dip switches to assign a certain address like in DMX mode:
switch
1
Binary DMX
1
channel offset
page 13 / 67
2
3
4
0
0
1
2
3
4
0
0
0
2
3
4
0
0
0
2
3
4
0
0
0
2
3
4
5
2
4
8
16
5
6
0
1
5
6
1
0
5
6
0
1
5
6
0
1
6
7
8
9
32
64
128
256
7
8
9
0
1
0
7
8
9
0
0
1
7
8
9
0
0
1
7
8
9
1
1
0
10
Switch 10 has to be ON (up)
for ArtNet operation
10
0
10
0
10
0
10
0
Publicité
Chapitres
Table des Matières
