Chapter 1: Setting Up; Connecting The Stereo - Sony CHC-P33D Mode D'emploi

Chapter 1:
Setting
Up

Connecting the Stereo

Installing the Speakers
Inserting the Batteries
Setting the Clock
EN
4

Chapter 1: Setting up

Connecting the
Stereo
Use the illustrations below to connect your
stereo.
If you want to connect any optional
components to the stereo, see "Connecting
Optional Equipment" in Chapter 6.
STEP 1 Connecting the
Speakers
For speakers installation, see "Installing the
Spearkers".
Right (R) and Left (L) satellite speakers
Connect the right speaker to the R
connectors and the left speaker to the L
connectors. Connect the grey cords with
white stripes to ' and the solid grey cords
to '.
Superwoofer
Connect the superwoofer to the WOOFER
connectors. Connect the grey cord with red
stripes to ' and the solid grey cord to '.
STEP 2 Connecting the
Aerials
FM lead aerial (supplied)*
AM loop aerial (supplied)
* Note: Extend horizontally
AM loop aerial connection
Connect the supplied loop aerial to the AM
and the y terminals.
To improve the FM reception
Connect an outdoor FM aerial to the FM
75Ω terminal, using a 75-ohm coaxial cable.
Important
Ground the external aerial from y terminal
against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
75-ohm coaxial cable
(not supplied)
Ground wire
(not supplied)
To improve the AM reception
After you connect the AM aerial, connect a
6- to 15-meter (20- to 50- feet) insulated
wire to the AM terminal. Connect the y
terminal to earth.
Important
Ground the external aerial from y terminal
against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
FM
75Ω
Insulated wires
(not supplied)
AM
FM
75Ω
AM
FM
75Ω
AM
Ground wire
(not supplied)