Recording A Cd; Recording A Cd: Specifying Tape Length (Time Edit) - Sony CHC-P33D Mode D'emploi

Recording a CD

You can record from a CD to a tape. You
can also record the sound adjusted by the
equalizer onto a tape (See "Selecting the
Audio Emphasis).
Use TYPE I (normal) or TYPE II (CrO
tapes. Do not use TYPE IV (metal) tapes for
recording.
To listen to other sources while recording,
you must stop recording.
Recording a CD
Automatically
By using CD SYNCHRO button, you can
record from a CD to a tape quickly. Use the
buttons on the unit to do this operation.
SYSTEM
POWERnON
DOLBY NR
5
1
Press § EJECT DECK B and insert a
blank tape into deck B with the side you
want to record on facing forward.
Recording will start from the front side
of the tape, unless you have changed the
playing direction before recording.
Make sure the tabs on the cassette have
not been removed.
2
Press § OPEN/CLOSE CD and place a
CD. Then, press § OPEN/CLOSE CD
again to close the disc tray.
3
Select dual or single-sided recording.
To record Press DIRECTION
MODE to select
A
One side
ß or RELAY
Both sides*
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
4
Press CD SYNCHRO.
Deck B stands by for recording.
5
Press P to release recording pause.
Recording starts. After about 10
seconds, the CD starts playing.
To stop recording
Press p.
To activate DOLBY NR
When you want to reduce the hiss noise in
low-level high-frequency signals, press
DOLBY NR so that "DOLBY NR B" appears
in the display after step 3.
Adjusting the volume or DBFB will not
affect the recording level
)
2
But these controls will change the sound
levels you hear through speakers or
headphones.
Recording a CD Manually
You can record a CD as you like, for
instance, record just the songs you want or
record from the middle of the tape.
SYSTEM
POWERnON
3
1
3
2
4
1
Press § EJECT DECK B and insert a
blank tape into deck B with the side you
want to record on facing forward.
Recording will start from the front side
of the tape, unless you have changed the
playing direction before recording.
Make sure the tabs on the cassette for
deck B have not been removed.
2
Press § OPEN/CLOSE CD and place a
CD. Then, press § OPEN/CLOSE CD
again to close the disc tray.
3
Press FUNCTION repeatedly until "CD"
appears in the display.
4
Select dual or single-sided recording.
To record
One side
Both sides*
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
5
When you want to reduce the hiss noise
in low-level high-frequency signals,
press DOLBY NR so that "DOLBY NR
B" appears in the display.
6
Press r REC.
Deck B stands by for recording.
7
Press P to release recording pause.
Recording starts.
8
Press CD.
The CD starts playing.
To stop recording
Press p.
Recording a CD:
Specifying Tape
Length (time edit)
You can have the stereo system create
programmes based on the tape length. The
CD player makes programmes that will fit
the tape length. For example, if you use a
40-minute tape to record a 46- minute CD,
5
the CD player will automatically choose
4
tracks that will fit within the 40-minutes,
filling as much of the tape as possible. The
1
player will not programme those tracks
2
with numbers greater than 20. Use the
buttons on both the unit and the remote to
6
do this operation.
8
7
10
4
Press DIRECTION
MODE to select
A
ß or RELAY
1
Press CD.
2
Press § OPEN/CLOSE CD and place a
CD. Then, press § OPEN/CLOSE CD
again to close the disc tray.
3
Press EDIT.
"TIME EDIT" appears in the display.
continue to next page
PLAY MODE
9
8
7
2
1
p
3,5,6
Chapter 4: the Tape Player
EN
13