Inventum IVW6015A Manuel D'utilisation page 49

Problem
There is food waste left on the
dishes.
There are white stains on the dishes. The amount of detergent is
The dishes are not dry.
There are rust stains on the dishes.
Possible cause
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The cutlery basket is too full.
The dishes are placed too close
together.
The amount of detergent is
insufficient.
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The level of water hardness is set
too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
Possible solution
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Choose a suitable program. Refer to
'Programs'
section .
Clean the spray arms. Refer to
'Cleaning the spray arms'
section
Clean the filters. Refer to section
'Cleaning the filters'
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Fill the salt reservoir. Refer to
'Filling the salt reservoir'
section
Adjust the level of salt consumption.
Refer to section 'Setting the level of
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
'Programs'
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
English
'Filling
.
'Filling
.
.
• 49