Replacing The Filters; Understand The Healthy Air Protect Lock; Replace Filter 2; Replace The Humidification Filter - Philips AC4O80 Mode D'emploi

6 Replacing the
filters
Understand the healthy
air protect lock
This appliance is equipped with the
healthy air protect lock to make sure
that the filters are in optimal condition
when the appliance is operating. When
the filter is almost full and has to be
replaced, the specific filter light ( / )
start to flash.
When you do not replace the filter in
time:
» The appliance stops operating
and it is locked.
» The specific filter light ( / )
illuminate continuously.
Note
•
The appliance is locked after the filter
light has flashed for approximately
2 weeks.

Replace filter 2

Note
•
Filter 2 is not washable nor vacuum
cleanable.
Replace filter 2 when the filter light
starts flashing (fig „).
1
Remove the filters using the tag on
the filter. Take the filters by both
sides and gently deposit them into
the house hold trash bin (fig d).
Note
•
Do not touch the pleated filter surface,
or smell the filter as it has collected
pollutants from the air.
•
Wash your hands after disposing of the
used filters.
2
Remove all packaging material from
the new filter 2 (fig e).
3
Put the new filter 2 into the
appliance (fig f).
4
After the pre-filter is put back in
the appliance, reset the filter 2
lifetime counter. (Refer to chapter 7
"Resetting the filter lifetime
counter")
Replace the
humidification filter
Replace the humidification filter when
starts flashing (fig ...).
filter light
1
Remove the used humidification
filter from the water tank (fig }).
2
Remove all packaging material of
the new humidification filter (fig i).
3
Put the new humidification filter in
the water tank (fig l).
4
Push the water tank back into the
appliance (fig m).
5
Reset the humidification filter
lifetime counter. (Refer to chapter 7
"Resetting the filter lifetime
counter")
EN 13