Gaggenau VL 414 110 Instructions D'utilisation page 12

3 Using the screws included, bolt down the control
panel on the bracket.
9
CAUTION
Appliance damage! Establish equipotential
bonding. Before the control cables may be
plugged onto the control panel, the stranded
grounding wire from the control unit must be
fitted on the control panel.
12
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Plug the control cable into the socket on the
control desk. The plug must snap into place.
2 Shorten the front cooktop clamp according to the
thickness of the worktop
predetermined breaking point.
Note: Make sure you do not shorten too much.
The clamping effect with respect to the worktop
must be ensured.
. Break off plates at the