Gaggenau VL 414 110 Instructions D'utilisation page 10

Combining several Vario devices:
VA 420 000/001/010/011 is required for the
combination of several Vario appliances. This is
available separately as a special accessory. Consider
additional space requirement for the connecting strip
between the appliances when making the cut-out (see
installation instructions VA 420 000/001/010/011).
Appliances can also be installed in individual cut-outs,
bearing in mind a minimum distance between the
devices of 2" (51 mm).
When combining several appliances with or without
appliance cover, you can use the appliance extensions
VA 450 110/-400/-600/-800/-900 (depending on
appliance width) to balance out dimension
differences.
10
The connecting strip Hole for control knobs
The built-in control panel can be integrated in the
bottom cupboard at drawer level. Panel thickness:
/ " - 1" (16 - 26 mm)
5
8
1 As shown in the figure, produce the Ø 1
(35 mm) holes for fastening the control knobs in
the front of the bottom cupboard. A drilling
template is provided for exact positioning of the
drill holes.
For flush installation:
/ "
3
8