Publicité
Les langues disponibles
Les langues disponibles
3. Install low-pressure (black) nozzle into quick connect fitting of spray
wand, refer to spray Wand nozzles. note: Chemicals and soaps
will not siphon if the black soap nozzle is not installed on the spray
wand.
4. After use of chemicals, place chemical hose into container of clean
water and draw clean water through chemical injection system to rinse
system thoroughly.
NOTICE: Risk of property damage. Failure to do so could cause
damage to the pump.
Pumps damaged due to chemicals will not be covered under
warranty.
Starting
WARNING: To reduce the risk of injury, read the pressure washer
instruction manual and the engine instruction manual before starting
pressure washer.
DANGER: Risk of fluid injection and laceration. When using the
high pressure setting, DO NOT allow the high pressure spray to come
in contact with unprotected skin, eyes, or with any pets or animals.
Serious injury will occur.
• Your washer operates at fluid pressures and velocities high
enough to penetrate human and animal flesh, which could result
in amputation or other serious injury. Leaks caused by loose
fittings or worn or damaged hoses can result in injection injuries.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
DANGER: Carbon Monoxide. Using an engine indoors can kill
you in minutes. Engine exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or smell. You
may be breathing CO even if you do not smell engine exhaust.
• Breathing ex h aust fumes will cause se r i o us injury or death!
En gine exhaust con tains carbon mon ox ide, an odorless and
deadly gas.
• Operate pressure washer in a well-ventilated area. Avoid
en closed areas such as ga rag es, base ments, etc.
• Never op e r a te unit in or near a lo c a t ion occupied by humans or
animals.
WARNING: Risk of fire, asphyxiation and burning. Never fill fuel tank
when engine is running or hot. Do not smoke when filling fuel tank.
• NEvEr fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below
bottom of filler neck to provide space for fuel expansion. Wipe any
fuel spillage from engine and equipment before starting engine.
• DO NOT let hoses come in contact with very hot engine
muffler during or immediately after use of your pressure
washer. Damage to hoses from contact with hot engine
surfaces will NOT be covered by warranty.
NOTICE: NEvEr pull water supply hose to move pres s ure washer.
This could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• NEvEr turn water supply off while pressure washer engine is
running or damage to pump will result.
• DO NOT stop spraying water for
more than two minutes at a time.
Pump operates in bypass mode
when spray gun trigger is not
pressed. When the temperature
inside the pump rises too high the
thermal relief valve (T, Fig. 9) will open
and release a gush of water in an
effort to lower the temperature inside
the pump. The thermal relief valve will then close. If pump is left
in bypass mode for more than two minutes internal compo-
nents of the pump can be damaged.
13
FIG. 9
T
Publicité
