Normal Sounds; Options - Whirlpool WHP1000SQ Guide D'utilisation Et D'entretien

Soak
Use the Soak cycle to help remove stains on fabrics. This cycle
provides a soak time with warm or cold water, followed by drain.
Extra water, a short tumbling phase for equal distribution of the
laundry, and a soaking time without drum movement help improve
the removal of stains. Drain without spin assures gentle treatment,
even for delicate items.
Clean Washer with AFFRESH™ cycle
Use the Clean Washer with AFFRESH™ cycle once a month to
keep the inside of your washer fresh and clean. This cycle uses a
higher water level in combination with AFFRESH
tablet or chlorine bleach to thoroughly clean the inside of your
washing machine. See "Cleaning Your Washer."
IMPORTANT: Do not place garments or other items in the washer
during the Clean Washer with AFFRESH™ cycle. Use this cycle
with an empty wash drum.

Normal Sounds

As with any new product, you will hear sounds that you are not
accustomed to. You may hear various sounds when the door is
locked or unlocked, and during the washing, rinsing, or spinning
process. Between changes in wash actions, there will be
momentary pauses. You will hear water spraying and splashing
during the wash and rinse cycles. These new sounds and pauses
are part of normal washer operation. See "Troubleshooting."

Options

You can customize your wash by adding options to your cycle
selections. You can add or change an option after starting a cycle
anytime before the selected option begins. Not all Options are
available with all cycles.
■ See the "Laundry Guide" section for an overview of possible
options for each Wash Cycle selection.
■ If an option is available with a selected cycle, the light for that
option will illuminate when selected.
■ If an option is unavailable with a selected cycle, there will be a
short tone and the light for that option will not illuminate when
selected.
Delay Start
Use this to begin the wash cycle later.
■ Press DELAY START until the desired time (in hours) shows in
the Estimated Time Remaining display.
■ Press START/PAUSE. The countdown to the wash cycle will
show in the display window.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent
residue from garments. This option provides an additional rinse
with the same water temperature as in the normal rinse. It is
16
automatic for the Whitest Whites cycle. You may select or
deselect by pressing OPTIONS button until Extra Rinse light
glows.
TumbleFresh™ option
Use this option when you are not able to unload your clothes,
soon after the wash cycle ends. This option provides periodic
tumbling for up to 6 hours to help freshen your clothes. During this
time, the "Done" indicator remains activated, the door remains
locked, and the TumbleFresh™ option indicator light will flash.
The TumbleFresh™ option will automatically stop and the door
lock will be released after this time expires, or if you press POWER
at anytime to unload your laundry.
washer cleaner
®
Temp
Each cycle has a preset water temperature setting. To change the
water temperature, select the TEMP button until the desired
setting is illuminated.
Select a water temperature based on the type of load you are
washing. Use the warmest wash water safe for fabrics. Follow
garment label instructions.
In wash water temperatures colder than 60ºF (15.6ºC), detergents
do not dissolve well. Soils may be difficult to remove.
Temperature Guide
Temp
SANITARY
HOT
WARM
COLD
In wash water temperatures colder than 60°F (15.6°C), detergents
do not dissolve well. Soils may be difficult to remove.
Sanitary Temp
This washer has a Sanitary Temp that is certified by NSF
International, an independent, third party testing and certification
organization. The certification verifies that this option eliminates
99.9% of bacteria typically found on clothing, bedding, and
towels. There is no carryover of bacteria between loads after the
option is complete.
Only Sanitary temperature option has been designed to meet the
requirements of NSF Protocol P172 for Sanitizing Efficacy.
Use the Sanitary temperature option to clean heavily soiled,
colorfast fabrics. This option combines a super hot water
temperature to help ensure the removal of heavy soils and stains.
It is recommended that you set your hot water heater to 120°F
(49°C) to ensure proper performance during this option.
The Sanitary Temp removes more than 95% of common
household allergens.
Suggested Fabrics
Sturdy colorfast fabrics
Heavy soils
Whites and pastels
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Certified to Sanitize