Understanding Normal Washer Sounds; Understanding What Happens In Each Cycle - Whirlpool TAWS700EQ2 Guide D'utilisation Et D'entretien

USING YOUR WASHER
U
NDERSTANDING NORMAL WASHER SOUNDS
Your new washer may make sounds your old one
didn't. Because the sounds may be unfamiliar, you
may be concerned about them. Don't be; most of
them are normal.
The following describes some of the sounds you
may hear and what causes them.
U
NDERSTANDING WHAT HAPPENS IN EACH CYCLE
When the Cycle Control knob is set to a number and
pulled out, the washer fills (to the selected water
level) before agitation and timing start. The washer
begins agitating immediately after filling; agitation
occurs with the washer lid up or down.
Sequence of cycles
Wash selected time
†
The Permanent Press cycle partially drains, fills, agitates
briefly, and drains.
10 10
WASH
Fill
†
Drain
No agitation
Spin
During drain
If water is drained quickly from your washer
(depending on your installation), you may hear air
being pulled through the pump during the end of
draining.
After drain and before spin
When the cycle changes from draining to spinning,
you may hear gears engaging.
After agitation starts, the Cycle Control knob turns
clockwise until it points to an Off area and the
cycle ends.
NOTE: The washer pauses briefly throughout
each cycle. These pauses are normal for washer
operation.
RINSE
Fill
Rinse
Drain-No agitation
Spin-Spray rinse
Spin
Off