Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(2) Driving in wood screws
Prior to driving in wood screws, make
pilot holes suitable for them in the
wooden board. Apply the bit to the screw
head grooves and gently drive the screws
into the holes.
After rotating the rotary hammer at low
speed for a while until a wood screw in
partly driven into the wood, squeeze the
trigger more strongly to obtain the
optimum driving force.
CAUTION:
Exercise care in preparing a pilot hole
suitable for the wood screw taking the
hardness of the wood into consideration.
Should the hole be excessively small or
shallow, requiring much power to drive
the screw into it, the thread of the wood
screw may sometimes be damaged.
6. Using depth gauge (Fig. 12)
(1) Loosen the knob on the side handle, and
insert the depth gauge into the mounting
hole on the side handle.
(2) Adjust the depth gauge position
according to the depth of the hole and
tighten the knob bolt securely.
Mounting hole
Knob on side
handle
Fig. 12
7. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 13)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 13)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
(4) To remove the drill bit (taper shank),
Depth gauge
Drill bit
Taper shank
adaptor
Fig. 13
insert the cotter into the slot of the taper
shank adaptor and strike the head of the
cotter with a hammer supporting on the
rests. (Fig. 14)
Taper shank adaptor
Cotter
Rests
Fig. 14
English
Grip
Front cap
11
Publicité
Table des Matières
