Electrolux EI24ID35Q Guide D'utilisation Et D'entretien page 7

O p e r a t i o n S e l e c t i o n
Delay
The Delay Start option allows you to automatically
delay starting your dishwasher from 2-4-6 hours.
Press DELAY pad until the LED of the desired
DELAY start is reached. If the door is opened while
the DELAY time is counting down, the DELAY LED
will blink.
To cancel the DELAY option and begin the cycle
before the delay period is over, press the CANCEL
pad and then the START pad.
Start/Pause
To start a cycle, press the START pad until you
hear a tone. The cycle starts when door is closed.
Cancel
To cancel a cycle at anytime, open the door and
press the CANCEL pad until you hear a tone. The
last cycle selected will be displayed. If desired, a
new cycle can now be selected by pressing START
pad and upon closing the door the cycle will begin.
NOTE
Your unit has DishSense
used to understand how heavily soiled the dish
load is so the cycle can be automatically adjusted
to the appropriate response. This helps to
prevent energy waste. The sensor is calibrated
at the end of the cycle. For the fi rst cycle after
power is applied (when fi rst installed or after a
power failure) the sensor will not be calibrated
and so cannot determine the soil load. Therefore,
your unit will provide a response suitable for
heavy soils on the fi rst run after power is restored.
This will assure that whatever is loaded will get
cleaned. Energy use during this fi rst run may be
higher than would be typical.
Operating Instructions
TM Technology that is
S t a t u s I n d i c a t o r L i g h t s
The WASHING Status Light comes on at the
beginning of the cycle and remains on until end of
the wash cycle.
The DRYING Status Light comes on at the
beginning of the dry cycle and remains on until end
of the cycle.
The CLEAN Status Light will come on at the end
of the cycle and will remain on until the door is
opened or any key is pressed. Once the door is
opened, the CLEAN Status Light will stay on for 15
seconds and then turn off.
If the SANITIZE option is selected and NSF
requirements are achieved, the SANITIZED Status
Light will come on at the end of the cycle and will
remain on until the door is opened or any key is
pressed. Once the door is opened, the SANITIZED
Status Light will stay on for 15 seconds. If the
SANITIZE option is selected but NSF requirements
are not achieved, the SANITIZED Status Light will
not come on.
E r r o r i n d i c a t i o n s
In the unlikely event the dishwasher malfunctions,
the 3 Delay LEDs blink constantly. If the Hi-
Temp LED blinks intermittently 1 time refer to
"Dishwasher won't run or fi ll" and try to solve the
problem. If the Hi-Temp LED blinks 2 times refer
to "Dishwasher does not drain properly" and try to
solve the problem. If, after the check, the problem
remains, or if the LEDs are still blinking, contact
the Electrolux Customer Care Center at 1-877-
435-3287. They will be able to provide assistance
in troubleshooting the problem and/or locating an
authorized service technician, if needed.
7