Nordica FLY Instructions Pour L'installation, L'utilisation Et L'entretien page 16

The one-piece ceramic glass of the door (resistant up to 700 ° C) allows a wonderful view on the burnin g flames.
Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth grate there is an extractable ash drawer, (Picture 8 pos. A ).
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of
the stove, the heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1A - PRIMARY AIR register (left lever)
Below the hearth door, on the front left side, there is the primary
air register, in the style of lever (Picture 1 - 1A )
With this air register, it is adjusted the passage of primary air
into the low part of the stove and through particular channels
flows in the fuel direction. The primary air is necessary for the
combustion process during lighting. The ash drawer must be
regularly emptied, so that the ash does not obstruct the entry of
the primary air for the combustion.
In order to open the air flow, the bar must be completely pulled
out.
During wood combustion, the register of primary air must be
opened only for a while, because otherwise the wood burns too
fast and the stove may overheat.
2A - SECONDARY AIR register (right lever)
Below the hearth door, on the right front side there is the
secondary air register (Picture 1 - 2A ).
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double combustion
and keeping at the same time the glass clean (with open register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2A ).
3. RULES FOR INSTALLATION
The stove, assembled and ready for the installation, must be connected with a junction to the existing flue of the
house.
Before installation, verify : UPPER smoke output – REAR smoke output ( see chap. 6)
The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections must be tight.
It is OBLIGATORY to respect the National and European rules, local regulations concerning building matter
and also fireproof rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention to
windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for the
connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped with a wall
connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your structure (chap. 16.2 - A ) can support the weight of the stove ( weight to support
more-equal to 200 kg USE resistant screws WITH METAL RAWPLUG (chap. 16.2 - B )).
In case of insufficient carrying capacity it is necessary to adopt appropriate measures.
La NORDICA S.p.A. responsibility is limited to the supply of the appliance. Your plant has to be carried out in
compliance with the state of the art, according to the provisions of these instructions and good professional
practice, by qualified personnel, acting for companies authorized to acquire the whole responsibility for the
whole plant.
LA NORDICA is not responsible in case of modification of the product and for the use of not original spare
parts. The hearths must not be modified.
THE HEARTHS MUST NOT BE MODIFIED.
16
1A
2A
7193500 Rev.06 – EN
FLY
Picture 1