Electrolux SB330NIMS Notice D'utilisation page 99

Error type Possible cause
E01 - E07
E08 Power supply to the
device has dropped to
below 170 V.
E10 Fridge compartment is
not cold enough.
E11 Fridge compartment is
too cold.
If the problems continue,
contact the Authorized
Service Centre.
9.2 What to do if...
Problem
The appliance does not
operate.
The appliance is noisy.
The compressor operates
continually.
Solution
Contact the nearest Authorized Service
Centre.
The voltage needs to be increased back
to required levels.
Set a colder temperature in the fridge
compartment.
• Switch off the Extra Cool function.
• Set a higher temperature in the fridge
compartment.
• Make sure that ventilation holes are
clear and not clogged.
In case of different problem with the
appliance, check the table below for
possible solutions.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri‐
cal appliance to the mains
socket. Contact a qualified
electrician.
Check if the appliance
stands stable.
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature be‐
fore storing.
99