Electrolux SB330NIMS Notice D'utilisation page 101

Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
The WiFi does not connect
with the appliance, the Wi‐
Fi indicator blinks.
Possible cause
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The Extra Freeze function
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The Extra Freeze function
is switched on.
There is no cold air circula‐
tion in the appliance.
The WiFi router does not
work.
The router needs a restart. Restart the router by un‐
ENGLISH
Solution
Wrap food in suitable
packaging before storing it
in the appliance.
Attach the melting water
outlet to the evaporative
tray.
Switch off the Extra Freeze
function manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"Extra Freeze function"
section.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "Extra Freeze
function" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and Tips" chapter.
Check whether the router
is ON and if other connec‐
ted devices are working. If
the router was OFF, turn it
ON, wait for a few minutes
and check again.
plugging and plugging it.
Wait a few minutes and
check again.
101