Wear Of The Brushes; Disposal And Legal Information; Environmental Protection And Device Disposal; Disposing Of The Packaging - Gloria MultiBrush SpeedControl Mode D'emploi

RZ_MULTIBRUSH_DE_GB_FR_NL_978410-1_Text_GB 10.11.16 15:55 Seite 30
You should therefore observe the
following safety instructions:
Switch off the device and disconnect
the power cord (C) from the power
supply.
Do not immerse the device in water
or spray or clean it with water.
The device must be protected
against moisture.
However, if the device does fall into
water, immediately unplug the
mains plug. Never reach into the
water if the device is still connected!
Clean the outside of the device with a
damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.
Ensure that the ventilation slots are
free of dirt.
In cases of heavier soiling of the roller
brush and/or joint brush units,
dismantle for thorough cleaning (see
Assembly/Disassembly as described in
Chapter 6.1.2).
Clean the brushes in water or with a
strong water jet and a hard brush.
Only use original GLORIA spare parts
for repairs.
Repairs must be carried out by a
GLORIA service point.

8.2 Wear of the brushes

NOTE!
If the surface brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
If the joint brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
9 Disposal & Legislation
9.1 Environmental protection &
disposal of the device
This symbol on the product, user man-
ual or packaging indicates that this
product must not be disposed of in
regular household waste at the end of
its service life.
The device including accessories e.g.
surface brush, joint brush etc. must be
disposed off at a recycling collection
point.
The materials can be recycled accord-
ing to their designations. You will
make an important contribution to the
protection of our environment by the
correct end-of-life product recycling,
material recycling or other form of
re-use.
NOTE!
Please check with your local govern-
ment to find the appropriate disposal
point.
9.2 Disposal of packaging
The packaging materials have been
selected according to environment ally-
suitable and disposal-related aspects
and are therefore recyclable.
Returning the packaging to the materi-
al circulation saves raw materials and
reduces the level of waste.
Please dispose of unwanted pack aging
materials according to applicable local
regulations.
Technical changes reserved!
30