Safety Instructions For Connecting The Device; Safety Instructions For Operating The Device - Gloria MultiBrush SpeedControl Mode D'emploi

RZ_MULTIBRUSH_DE_GB_FR_NL_978410-1_Text_GB 10.11.16 15:55 Seite 22
Wear suitable work clothing such as
sturdy shoes, safety goggles, long
trousers and, if necessary, gloves
during cleaning. Do not work
barefoot or in light sandals.
If the device is passed on to other
persons, they must also be given the
user manual!
Only use GLORIA original spares and
accessories for the device.
Never use worn, modified or defec-
tive replacement parts / accessories!
2.2 Safety instructions for
connecting the device
WARNING!
Danger of electric shock!
Contact with energised cables/wires
or components may result in serious
injury or death!
You should therefore observe the
following safety instructions:
If the power cable is damaged,
it must only be replaced by a repair
shop designated by the manufactur-
er in order to prevent a hazard !
Please contact the manufacturer or
the customer service department.
Ensure that the supply voltage
corresponds with the voltage (V)
of the device !
Only connect the device to an AC
grounded power outlet.
When using an extension lead, only
use a grounded cable for outdoor
use with a conductor cross-section
of at least 1.5 mm
The device should be operated
using a residual-current-operated
protective device (RCD) with a
release current of no more than
30 mA.
Ask your elec trical installer!
The mains plug must be removed:
- In the event of faults during
operation
- Prior to any cleaning
- After use
!
2
22
2.3 Safety instructions for
operating the device
WARNING!
Danger of electric shock!
If the energised device comes into
contact with water, there is a risk of
serious injury or death!
You should therefore observe the
following safety instructions:
Do not use the device with wet hands.
Do not immerse the device in water
or spray or clean it with water. The
device must be protec ted against
moisture. However, if the device
does fall into water, immediately
unplug the mains plug.
Never reach into the water if the
device is still connected!
NEVER drive over the extension
cable with the device!
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
Parts of the device can become hot
during use and may cause burns.
It is therefore important to observe
the following safety instructions:
Wear protective gloves during
assembly and cleaning work!
Observe the following safety
precautions to prevent injuries
and material damage due to misuse
and unsafe handling of the product.
Misuse can result in INJURIES.
CAUTION! RISK OF INJURY
DURING OPERATION!
Use the device as intended!
Work only within the specified
perform ance range.
Before each use, make sure that the
device is in perfect condition;
operation is prohibited if:
- the safety devices (start switch,
protective covers) and/or brushes
are damaged or worn.
- the device shows visible signs of
damage.