Quick Start (For Introduction); Ready For Training; Start Of Training; End Of Training - Kettler SM3305-68 Mode D'emploi Et Instructions D'entraînement

Training and Operating Instructions
16
GB
Quick start
(for introduction)
Without special settings
• press a key
Display
• All segments are shortly displayed (segment test).
• The total kilometres are shortly displayed.
Subsequently change to the display "Reading for trai-
ning".

Ready for training

Display
All segments display "Zero", except for pulse (if activated)
and brake level.
Start training by pedalling.

Start of training

Display
• Pedal rotation segments, distance, speed, energy and
time increase.
• Pulse (if activated).
Brake setting levels 1-10
• Turn hand wheel to the right to increase the brake
level; turn hand wheel to the left to decrease the brake
level.
Training interruption/end of training
If you interrupt or complete your training, average values
of the last training unit are displayed with the Ø symbol.
Display
• Average values Ø:
pedal rotation segments, speed, brake level and pulse
(if activated).
• Total values:
distance, energy and time.

Sleep mode

Four minutes after the end of training, the device switches into
the sleep mode. If you press a key, the display starts again
with the segment test, odometer and ready for training.
Notice:
Display values
The illustrations show the operation as exercice bike.
If the rotation speed corresponds to the example values on the
display, the values for speed and distance at the crosstrainers
are lower.
At a pedal rate of 60 min-1
exercise bike = 21.3 km/h
Crosstrainer = 9.5 km/h