Publicité
Les langues disponibles
Les langues disponibles
English
Fig. J
8
4. Keeping fingers clear of the track, close the magazine by
releasing the pusher latch. Carefully allow the latch to
slide forward and engage the nail strip.
Unloading the Tool
WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Slide the spring-loaded pusher latch to the base of the
magazine to lock it into place.
2. Tip the tool up until the fastener strip slides freely out of
the magazine.
3. With battery removed, check the nosepiece to verify
there are no nails remaining.
Dry Fire Lock Out
The nailer is equipped with a dry fire lockout which prevents
the tool from actuating when the magazine in nearly empty.
When approximately 4 nails remain in the magazine, the
tool ceases to operate. Refer to Loading the Tool to reload a
stick of collated nails.
Adjusting Depth (Fig. K)
The depth that the nail is driven can be adjusted using the
depth adjustment wheel
on the nose of the tool.
3
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
•
Remove battery pack.
•
Engage trigger lock-off.
•
Always point the nose of the nailer away
from you.
•
Avoid contact with trigger during adjustments.
1. To drive the nail shallower, rotate the depth adjustment
wheel
3
to the left, toward the shallow nail icon.
2. To drive a nail deeper, rotate the depth adjustment
wheel
3
to the right, toward the deeper nail icon.
12
Fig. K
3
Non-Mar Tip (Fig. L)
When using this tool on softer materials that you do not
want to mark, such as wood cladding, use the plastic non-
mar tip
15
over the contact trip
Fig. L
6
15
Jam/Stall Indicator Light (Fig. A)
There is a jam/stall indicator light
the tool.
JAM/sTAll COnDiTiOn
Rotate the stall release
lever to release. Refer to
Stall Release.
Stall Release (Fig. M)
If the nailer is used in harder wood where all available
energy in the motor is used to drive a fastener, the tool
may stall. The driver blade will not complete the drive cycle
and the jam/stall indicator will flash. Rotate the stall release
lever
5
on the tool and the mechanism will release.
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted. If the driver
blade does not automatically return to the home position,
proceed to Clearing a Jammed Nail. If the unit continues
to stall please review the material and fastener length to be
sure that it is not too rigorous an application.
6
.
located on the foot of
4
Publicité
