Sony DSX-B41D Mode D'emploi page 6

Pairing with a BLUETOOTH
Device
When connecting a BLUETOOTH device for
the first time, mutual registration (called
"pairing") is required. Pairing enables this
unit and other devices to recognize each
other. This unit can connect two BLUETOOTH
devices (two mobile phones, or a mobile
phone and an audio device).
1
Press MENU, then rotate and press
the control dial to select [BLUETOOTH]
 [SET PAIRING]  [SET DEVICE 1]/[SET
DEVICE 2]*.
flashes while the unit is in pairing
standby mode.
* [SET DEVICE 1] or [SET DEVICE 2] will be
changed to the paired device name after
pairing is complete.
2
Perform pairing on the BLUETOOTH
device so it detects this unit.
3
Select your model name shown in the
display of the BLUETOOTH device*.
When pairing is made,
* If passkey input is required on the BLUETOOTH
device, input [0000].
6
GB
stays lit.
Canceling the
Demonstration Mode
You can cancel the demonstration display
which appears when the source is off and
the clock is displayed.
1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [SET
DEMO], then press it.
3
Rotate the control dial to select [SET
DEMO-OFF], then press it.
The setting is complete.
4
Press (back) twice.
The display returns to normal reception/
play mode.
Updating the Firmware
To update the firmware, visit the support site
on the back cover, then follow the online
instructions.
Notes
• Using a USB device (not supplied) is required for
updating the firmware. Store the updater in the
USB device, and connect the device to the USB
port, then perform the update operation.
• Updating the firmware takes a few minutes to
complete. During the update, do not turn the
ignition to the OFF position, nor remove the USB
device.
Resetting the Unit
1
Press and hold DSPL and
more than 2 seconds.
CALL for