Important Safety Instructions For Use Of The Battery And Battery Charger; Caution On Lithium-Ion Battery - Hitachi G 14DSL Instructions De Sécurité Et Mode D'emploi

Masquer les pouces Voir aussi pour G 14DSL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

*
If the input rating of a battery charger is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating–for example:
1,250 watts
125 volts
9.
Do not operate battery charger with damaged cord
or plug-replace them immediately.
10. Do not operate battery charger if it has received a
sharp blow, been dropped, or otherwise damaged
in any way; take it to a qualified serviceman.
11. Do not disassemble battery charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk
of electric shock or fire.
12. To reduce risk of electric shock, unplug charger
from receptacle before attempting any
maintenance or cleaning. Removing the battery
will not reduce this risk.
IMPORTANT SAFETY INSTRUCTIONS FOR
USE OF THE BATTERY AND BATTERY
CHARGER
You must charge the battery before you can use the
power
tool.
Before
UC18YRSL / UC18YFSL battery charger, be sure to read
all instructions and cautionary statements on it, the
battery and in this manual.
CAUTION
USE ONLY HITACHI BATTERY TYPE BSL1430 AND
BSL1830. OTHER TYPES OF BATTERIES MAY
BURST AND CAUSE INJURY!
Follow these instructions to avoid the risk of injury:
WARNING:
Improper use of the battery
or battery charger can lead
to serious injury. To avoid
these injuries:
1. NEVER
disassemble the battery.
2. NEVER
incinerate the battery, even if it is
damaged or is completely worn out. The
battery can explode in a fire.
3. NEVER
short-circuit the battery.
4. NEVER
insert any objects into the battery
charger's air vents. Electric shock or
damage to the battery charger may
result.
5. NEVER
charge outdoors. Keep the battery away
from direct sunlight and use only where
there is low humidity and good
ventilation.
6. NEVER
charge when the temperature is below
32°F (0°C) or above 104°F (40°C).
= 10 amperes
using
the
model
7. NEVER
connect two battery chargers together.
8. NEVER
insert foreign objects into the hole for
the battery or the battery charger.
9. NEVER
use a booster transformer when
charging.
10. NEVER
use an engine generator or DC power to
charge.
11. NEVER
store the battery or battery charger in
places where the temperature may reach
or exceed 104°F (40°C).
12. ALWAYS operate charger on standard household
electrical power (120 volts). Using the
charger on any other voltage may
overheat and damage the charger.
13. ALWAYS wait at least 15 minutes between
charges to avoid overheating the
charger.
14. ALWAYS disconnect the power cord from its
receptacle when the charger is not in
use.

CAUTION ON LITHIUM-ION BATTERY

To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 to 3 described below, when using this
product, even if you are pulling the switch, the motor
may stop. This is not the trouble but the result of
protection function.
1.
When the battery power remaining runs out, the
motor stops.
In such case, charge it up immediately.
2.
If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
3.
If the battery is overheated under overload work,
the battery power may stop.
In this case, stop using the battery and let the
battery cool. After that, you can use it again (only
BSL1830).
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1.
Make sure that swarf and dust do not collect on
the battery.
During work make sure that swarf and dust do not
fall on the battery.
Make sure that any swarf and dust falling on the
power tool during work do not collect on the
battery.
Do not store an unused battery in a location
exposed to swarf and dust.
Before storing a battery, remove any swarf and
dust that may adhere to it and do not store it
together with metal parts (screws, nails, etc.).
English
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

G18dsl

Table des Matières