Oven Location And Ventilation - Blodgett Combi CNV14E Manuel D'installation

OVEN LOCATION
The well planned and proper placement of your
oven will result in long term operator convenience
and satisfactory performance.
Certain minimum clearances must be maintained
between the oven and any combustible or non-
combustible construction. See the table below.
In addition, the following clearances are recom-
mended for servicing.
Oven body sides --- 12" (30cm)
D
Oven body back --- 12" (30cm)
D
NOTE: On gas models, routine servicing can usu-
ally be accomplished within the limited
movement provided by the gas hose re-
straint. If the oven needs to be moved fur-
ther from the wall, the gas must first be
turned off and disconnected from the oven
before removing the restraint. Reconnect
the restraint after the oven has been re-
turned to its normal position.
Left Side Heat Shield
Heat sources should not be near the air vents lo-
cated on the left hand side of the gas appliance.
Consult the factory for optional protective side
heat shield.
CNV14 P/N R9527
MINIMUM REQUIRED
CLEARANCES
Oven
Model M d l
Right
Side
CNV14E 1"
(25.4mm)
CNV14G 1"
(25.4mm)
Left Back
Side
4" 6"
(101.6mm) (152.4mm)
6" 6"
(152.4mm) (152.4mm)

Oven Location and Ventilation

VENTILATION
The necessity for a properly designed and in-
stalled ventilation system cannot be over empha-
sized. The ventilation system will allow the unit to
function properly while removing unwanted vapors
and products of combustion from the operating
area.
The appliance must be vented with a properly de-
signed mechanically driven exhaust hood. The
hood should be sized to completely cover the
equipment plus an overhang of at least 6" (15 cm)
on all sides not adjacent to a wall. The capacity of
the hood should be sized appropriately and provi-
sions made for adequate makeup air.
WARNING!!
Failure to properly vent the oven can be
hazardous to the health of the operator;
and will result in operational problems,
unsatisfactory baking, and possible dam-
age to the equipment. Damage sustained
as a direct result of improper ventilation
will not be covered by the Manufacturer's
warranty.
U.S. and Canadian Installations
Refer to your local ventilation codes. In the ab-
sence of local codes, refer to the National ventila-
tion code titled, "Standard for the Installation of
Equipment for the Removal of Smoke and Grease
Laden Vapors from Commercial Cooking Equip-
ment", NFPA-96- Latest Edition.
General Export Installations
Installation must conform with Local and National
installation standards. Local installation codes
and/or requirements may vary. If you have any
questions regarding the proper installation and/or
operation of your unit, please contact your local
distributor. If you do not have a local distributor,
please call Blodgett Combi at 0011-802-860-3700.
5
Installation