Turning Off The Steam Iron; Cleaning; Storage; Troubleshooting - SilverCrest DB 1400 A1 Mode D'emploi

Turning off the steam iron

• Remove the plug from the wall socket.
• Empty the water tank and clean the ironing
sole 0.
• Put the steam iron on the appliance base 9
after it has cooled down.

Cleaning

Potentially fatal danger!
Disconnect the plug before cleaning. Otherwise
there is a risk of receiving a potentially fatal electric
shock!
Risk of physical injury!
Allow the appliance to cool before cleaning it.
If you do not, there is a risk of receiving burn
injuries!
• Clean the casing with a soft, dry cloth only.
Attention!
Do not use aggressive, abrasive or chemical cleaning
agents. These could attack the surfaces and cause
irreparable damage to the appliance.
• Clean the soleplate 0 using a damp cloth and
a mild, non-scouring detergent.

Storage

Store the appliance in a clean, dust-free, and dry
location after it has cooled down.

Troubleshooting

Steam iron producing little or no steam:
The reserves of water in the steam iron are depleted.
Fill the water tank with tap water (See "Filling the
water tank").
The steam iron does not get hot:
• The steam iron is not plugged in or is not switched
on. Insert the plug into a wall power socket and
adjust the thermostat 6 to the desired ironing
temperature.
• The steam iron is defective. Arrange for the steam
iron to be repaired by qualified specialists.

Disposal

Do not dispose of the appliance in your
normal domestic waste. This appliance
is subject to the provisions of European
Directive 2012/19/EU.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
- 7 -