Searching A Handset From The Base; Managing Multiple Handsets; Setting Up An Additional Handset - Topcom BUTLER 3500 Mode D'emploi

5.1.3 Deleting an entry
To delete an entry:
1. Enter the menu by pressing
2. Select PHONE BOOK using the up
3. Press OK
4. Select DELETE ENTRY using the up
5. Press OK
6. Move through the list of names using the up
7. Press OK when you find the name you wish to delete
8. CONFIRM appears, press OK to confirm or

5.2 SEARCHING A HANDSET FROM THE BASE

When the paging button
handset. By simply pressing one of the handset keys the ringing stops.

6. MANAGING MULTIPLE HANDSETS

6.1 SETTING UP AN ADDITIONAL HANDSET

!!! YOU ONLY NEED TO REGISTER A 2nd HANDSET IN CASE YOUR 2nd HANDSET DOES NOT LINK
WITH THE BASE ANYMORE OR WHEN YOU HAVE BOUGHT A NEW ONE !!!
You can register new handsets on the base if these handsets support the DECT GAP protocol.
The base can support a maximum of 2 handsets. If you already have 2 handsets, and you wish to add another one or
change one handset, you must first delete a handset, then associate the new handset.
To register any handset, the base must be put into a special registration mode:
1. Press and hold the paging key
2. The base will then emit a beeptone. The base is now ready to register a new handset. You have 90 seconds after
pressing the button to register a new handset.
After putting the base into registration mode, start the procedure on the new handset:
if your additional handset is a Butler 3500xC
3. Enter the menu by pressing
4. Select REGISTER using the up
5. Press OK
6. Select REG BASE using the up
7. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
8. Enter the Base PIN code (0000 by default )
9. Press OK. The handset will start searching for the DECT base
10. If the handset has located the base, it will display the base identification number, validate the
base registration by pressing OK or stop by pressing
11. If the handset does not locate the base, it will return to the standby mode after a few seconds.
Try again by changing the base number and check that you are not in a environment where there
is interference. Move closer to the base.
if your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out how to register the handset.
The handset must be GAP compatible.
The icon and the text "NOT REG" flashes on the display when the handset is not associated with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this number that is
displayed on the handset after the name and must be used for internal calls.
Topcom Butler B3500/3501/Twin
/OK
and down
and down
and down
to stop.
on the base is pressed all the handsets will ring. This ringing will help you locate a lost
of the base for 6 seconds.
/OK
and down
and down
keys
keys
keys the list scrolls in alphabetical order.
keys
keys
.
Topcom Butler B3500/3501/Twin
17