Honeywell HCE80 Mode D'emploi page 23

Binding the room thermostat DTS92 with
the underfloor heating controller
Setting the underfloor heating
controller to the binding mode
Keep the zoning plan at hand.
1
Press and hold the installation
2
button
controller for 2 seconds.
The LED lights up. The LED
of zone 1 flashes green.
The underfloor heating controller waits
for the room thermostat signal.
!
In order to assign the room
thermostat to a different zone,
press the installation button
repeatedly until the LED of the
desired zone flashes green.
Setting the DTS92 to the binding mode
Keep the
1
long to set the room thermostat to standby.
Keep the ▲ and ▼ buttons pressed
2
simultaneously for 3 seconds.
INst should be displayed.
Press the ▼ button.
3
COnt should be displayed.
Press the ▲ button thrice.
4
CLr should be displayed.
Press the
5
existing connecting data.
Press the ▲ button.
6
COnt should be displayed.
Press the
7
send the connecting signal.
The room setpoint temperature and
the measured room temperature are
assigned to the selected zone.
The LED of the selected zone at
the underfloor heating controller
lights continuously orange.
HCE80(R) / HCC80(R) Mounting and operation
on the underfloor heating
button pressed 2 seconds
button once to delete
button once to
Binding
Press the installation button
1
the underfloor heating controller
twice (skip red flashing LED).
The green LED of the next
zone flashes green.
Establishing a binding to further zones
Press the installation button
1
underfloor heating controller until the
LED of the desired zone flashes green.
Resetting the DTS92 to normal mode
Keep the
1
symbol is displayed in the bottom
right-hand corner of the display.
Again keep the
2
the symbol disappears in the bottom
right-hand corner of the display.
at
at the
button pressed until the
button pressed until
19