Binding The Underfloor Heating Controller Without Time Program - Honeywell HCE80 Mode D'emploi

18

Binding the underfloor heating controller without time program

T87 RF
DTS92A(E) HCW82
Option
!
Only one room setpoint generator/sensor
can be assigned to a temperature zone.
If a room temperature sensor HCF82
is combined with a room setpoint
generator HCW82 or DTS92/T87RF,
i.e. assigned to the same zone, first
assign the room setpoint generator and
then the room temperature sensor.
If the installation button
underfloor heating controller is not
pressed for longer than 4 minutes, the
underfloor heating controller returns
automatically to normal mode.
!
Without a time program the underfloor
heating controller operates with a
basic value of 20°C (heating mode)
or 26°C (cooling mode). Please
refer to Page 22 for information
about checking the configuration.
Connecting devices (binding)
HCF82
at the
The following section describes how
you can assign (bind) the various
components of a temperature zone.
Setting the parameter SU at the room thermostat DTS92
The parameter SU:2 has to be set so that
the room thermostat DTS92 can be assigned
directly to the underfloor heating controller.
Keep the
1
until the
bottom right-hand corner of the display.
Keep the ▲ and ▼ buttons pressed
2
simultaneously until INst is displayed.
Press the ▲ button.
3
Ot is displayed.
Press the ▲ button until Su is displayed.
1 4
Press the
5
The current setting of the
parameter SU flashes.
If applicable, use the ▲ and ▼
6
buttons to select the setting "2"
and confirm with the
The parameter SU flashes.
Keep the
7
flashing stops and the
is displayed in the bottom right-
hand corner of the display.
Keep the
8
symbol disappears in the bottom
right-hand corner of the display.
The DTS92 is back in normal mode.
button at the DTS92 pressed
symbol is displayed in the
button.
button.
button pressed until
symbol
button pressed until the