Publicité
Les langues disponibles
Les langues disponibles
G
IMPORTANT SAFETY INSTRUCTIONS FOR THE
B
INSTALLATION
- ATTENTION -
FOR THE SAFETY OF THE PEOPLE IT IS IMPORTANT TO FOLLOW ALL
THE INSTRUCTIONS.
FOLLOW ALL INSTALLATION INSTRUCTIONS
1° - This handbook is exclusively addressed to the specialized personnel who
knows the constructive criteria and the protection devices against the accidents
for motorized gates, doors and main doors (follow the standards and the laws in
force).
2° - The wiring harness of the different electric components external to the operator
(for example photoelectric cells, flashlights etc.) must be carried out according to
the EN 60204-1.
3° - The possible assembly of a keyboard for the manual control of the movement
must be done by positioning the keyboard so that the person operating it does not
find himself in a dangerous position; moreover, the risk of accidental activation of
the buttons must be reduced.
4° - Keep the automatism controls (push-button panel, remote control etc.) out of the
children way. The controls must be placed at a minimum height of 1,5 m from
the ground and outside the range of the mobile parts.
5° - Before carrying out any installation, regulation or maintenance operation of the
system, take off the voltage by operating on the special magnetothermic switch
connected upstream it.
THE RIB COMPANY DOES NOT ACCEPT ANY RESPONSIBILITY for possible damages
caused by the non observance during the installation of the safety standards and of the
laws in force at present.
KEEP THESE INSTRUCTIONS WITH CARE
1° - If it is not forecast in the electric gearcase, install a switch of magnetothermic
type upstream, (omni polar with minimum port of the contacts of 3 mm) with a
check of conformity to the international standards. Such devise must be protected
against the accidental lockup (for example by installing inside a locked board).
2° - For the section and the type of the motor cables, RIB advices to use a cable of
the H05RN-F type with minimum section of 2,5 sqmm and, in any case, to keep
to the IEC 364 standard and to the installation standards in force in your country.
N.B.: The system must be grounded
Data described by this manual are only Indicative and RIB reserves to modify them at
any time. Install the system complying with current standards and regulations.
3
Publicité
