Publicité
Les langues disponibles
Les langues disponibles
3.1 OPTIONAL RADIORECEIVER CONNECTIONS
Please refer to the instructions of RX433-A 1CH - RX433-A 2CH.
After the radio receiver has been connected, it can be glued, thanks to its bi-adhesive to the control board plastic top box, preferable from to the interior side. If you do not install a
dedicated aerial, is suggest connecting a wire, 17cm long, to the first pin of the radio receiver terminal block.
4. SETTINGS
This chapter contains important informations for a secure and correct installation.
Follow exactly all the instructions because a wrong installation can cause serious damages to the automation.
4.1 PRELIMINARY CHECKS
Before powering up the control panel, check the wirings.
In particular check that there are no damaged wires, short-circuits between wires and that all the accessories are connected to the terminal board in the points indicated in the diagram on
the previous page.
Once the power supply is on check that:
1. The POWER LED is constantly on.
2. The radio module is inserted and working.
3. The motor and the encoder connections are correct by following the procedure described below.
This procedure allows us to check the rotation sense of the motors, any possible blockages during the movement of the chain.
It is important to carry out this check in order to locate any wiring errors or anything else that can jeopardize.
N.B.: During this handling the photocells, the radio and the buttons are NOT active.
SW1 position
Push the BLUE button.
MAN
AUT
The chain begins to lower.
YES
SW1 position
Release the BLUE button and press the YELLOW button.
MAN
AUT
The chain begins to lift to the complete upper position.
4.2 MANUAL MOVING
This procedure must be carried out ONLY by the installer and ONLY during the setting up of the system.
The movement can be effectuated in particular situations in which it is not possible to move the chain to the lifted position in automatic mode.
To lift the chain
SW1 position
MAN
AUT
To lower the chain
NO
The Chain does not move.
The chain begins to lift.
NO
YES
NO
Press the YELLOW button
Press the BLUE button
23
Check the cables and repeat the test.
Modify the orientation of the 2 jumpers present on the card.
If not present, invert the phases of the motor.
Repeat the test.
Check the cables and repeat the test.
WARNING: the reactivation of the automatic mode (AUT)
implies the use of the reached position as totally
lifted position.
WARNING: During the manually moving, the anti-squeezing
safety is not active.
G
B
Publicité
