Beta 599DGT-AN/10 Notice D'utilisation Et Instructions page 22

OPERATION MANUAL AND INSTRUCTIONS
SETTING SUBMENUS
To enter the submenus, keep pressed for a few seconds, until the wrench emits a sound. To scroll the submenus, press .
The submenus are available in the following order:
- Measurement mode (MODE)
It allows selection of the PEAKHOLD or TRACK measurement mode, by pressing . The current operation mode is
shown on the bottom right.
- Unit of measurement (A-UI)
It allows selection of the unit of measurement of the torque in the angle mode (N·m, in·lb, ft·lb, kg·cm) by pressing . In
the PEAKHOLD mode, once the set angle has been reached, the end torque value reached with such unit as selected in the
current submenu is displayed on the screen alternatively with the latter.
- Button lock (LoC)
It allows locking of the buttons. Press to set the button lock function to "on" to enable it, and to "oFF" to disable it.
- Silent mode (bU)
It allows disabling of the acoustic signal. Press to set the button lock function to "on" to enable it, and to "oFF" to
disable it.
- Stored data
It allows the stored data to be displayed. Pressing will cause the progressive number and the value of the data to
alternate.
Individual values can be deleted by pressing .
The message "non E" means that no data has been stored.
- Data deletion (CLR-A)
It allows all the stored data to be deleted. To delete them, press ; to confirm, press ; to cancel, press . .
- ID User definition
You can select the user who is performing the tightening operations (up to 16 IDs). Such information will be downloaded to
the software after the data have been downloaded.
- Number of tightenings above 60% of tool capacity
The message "no-0" and the number of tightenings above 60% will be shown alternatively (e.g. the message "0002" will be
shown for two tightenings). The number can only be reset if the tool is recalibrated.
22
U/S
EN
U/S
U/S