Publicité
Les langues disponibles
Les langues disponibles
OPERATION MANUAL AND INSTRUCTIONS
STEP 3: SETTING TORQUE/ANGLE VALUE
After selecting the unit of measurement, you can set the torque/angle value through dedicated buttons .
In the torque + angle mode, the required values must be set separately. To adjust either value, press buttons when this is
superimposed.
Presetting value
Press
Decrease angle
Press
Increase angle
STEP 4: CHECKING MODE OF MEASUREMENT
The wrench can be used in two different modes; the current mode is displayed on the bottom right through the symbols, "T"
(TRACK mode) and "P" (PEAKHOLD mode).
• TRACK mode operation.
This mode allows the applied torque/angle value to be immediately displayed. It DOES NOT ALLOW the tightening data to be
stored. It allows quick switching from a tightening value to another, as the data is immediately reset by removing the applied
load.
• PEAKHOLD mode operation.
This mode allows the data to be stored after tightening, as the reached value remains superimposed.
18
Press
Increase torque
Press
Decrease torque
EN
Publicité
