Beta 599DGT-AN/10 Notice D'utilisation Et Instructions page 21

ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS
Angle readout mode
START
INIZIO
Press
Resetting?
Set required angle
Current angle
80% of target angle reached
Current angle
Note:
1. In the Angle Mode, pressing will cause the message to be displayed. Press again to reset the angle. Alternatively,
the torque will be reset.
2. Before resetting the angle, place the wrench on a firm plane horizontally; otherwise, this procedure may not be carried out correctly,
thereby resulting in an error .
3. When entering the "angle mode", press either "up" or "down" to set the required torque and angle values.
4. When the wrench is released, in the "angle mode", the display will show the corresponding torque value with blinking LEDs.
5. When 80% of the target value is reached, the green LEDs will start blinking, and an intermittent sound will be heard.
6. When 99.5% of the set value is reached, a continuous sound will be heard, and the green LEDs will stop blinking and will remain on,
together with the red LEDs.
7. Press button "M" to store the reached angle value.
Press
* Note 1
Wait 1 second
* Nota 3
Automatic
change
Apply as much as needed to reach target torque and rotate
Release force
Automatic
switch
* Notes 4 e 7
Apply as much as needed to reach target torque and rotate
80% of target angle reached
((...((...
* Note 5
Target angle reached
Release force
Automatic
switch
((...((... ...)) ...))
Resetting
* Note 2
Set torque
Current torque
...)) ...))
Current torque
* Note 6
EN I
21